Le joint technique, Fabricant de joint d'étanchéité

Typically, and by analogy with the existing situation, the transformation of rubbers and rubber silicones takes place in layers.

The flash generated by the complete filling of the impressions is then refinished, either by means of cryogenics, tribofinishing or manual deflashing.

LJT now has a modern, attractive alternative: flashless technology.

This flashless molding technology has many advantages:

• Material gain of approximately 15 to 30%
• Finished parts at the foot of the press
• Automation, robotization
• Gains on annual capacities
• Cleanliness of finished parts

This technology is justified for the production of large series because the investments in tools and robotization are significantly higher than for a traditional equipment.